After upgrade to ver 0812.cfw, my BlueStar stopped working
![Post Post](./styles/prosilver/imageset/icon_post_target.gif)
Hi,
My BlueStar module has never worked correctly as it had tons of problems with sound levels when an incoming call is received. Either the volume was too high or too low and had to be adjusted every time a call was received. During the next call, the volume level would not be saved and the same behavior occurred.
Since I had stopped using it for a couple of months, I was hoping that recent firmware addressed/solved some of these problems. Unfortunately, after upgrading my unit to firmware ver. 812, the module just blinks red and green in an alternating pattern whenever connected to either the USB port or the onStar connectors.
Trying to upgrade the firmware to a more recent release, (or any other firmware), the tool does not even detect the unit being connected. I have attempted to installed the CPU app on multiple machines; however, after installing the latest drivers and the latest version of the app, the results are the same: blinking RED/GREEN and no functionality or upgrade possible.
Is there anything I can do to recover the module? Was it a bad flash that broke my unit? Can I sent it for repair or recover?
Please let me know as I would like to continue using this product in my equinox 2007.
Thanks in advance for any replies.
My BlueStar module has never worked correctly as it had tons of problems with sound levels when an incoming call is received. Either the volume was too high or too low and had to be adjusted every time a call was received. During the next call, the volume level would not be saved and the same behavior occurred.
Since I had stopped using it for a couple of months, I was hoping that recent firmware addressed/solved some of these problems. Unfortunately, after upgrading my unit to firmware ver. 812, the module just blinks red and green in an alternating pattern whenever connected to either the USB port or the onStar connectors.
Trying to upgrade the firmware to a more recent release, (or any other firmware), the tool does not even detect the unit being connected. I have attempted to installed the CPU app on multiple machines; however, after installing the latest drivers and the latest version of the app, the results are the same: blinking RED/GREEN and no functionality or upgrade possible.
Is there anything I can do to recover the module? Was it a bad flash that broke my unit? Can I sent it for repair or recover?
Please let me know as I would like to continue using this product in my equinox 2007.
Thanks in advance for any replies.